|Payment Terms:||L/C,D/A,D/P,T/T,Western Union,MoneyGram|
|Supply Ability:||200 Ton/Tons per Month|
|Other Names:||Silicone conformal coating|
|Place of Origin:||Shanghai China|
|Main Raw Material:||Silicone|
|Model Number:||Becoat 921|
|Delivery Detail:||7 work days|
|Packaging Detail:||30CC/pcs;310 ML/tube;1L/plastic bottle;|
The Becoat 921 Silicone Coating is a low viscosity neutral silicone with a solids content of 100%, easy to spray, dip, brush or cast. Protective coating for hard and soft printed circuit boards and protective coating of impregnated porous substrates.
l Single component, low viscosity solvent-free, environmentally friendly
l High transparency, room temperature curing, good adhesion
l After curing at -60 - 200 ℃ stable and flexible
l And most of the substrate without primer coating has a good adhesion
l Excellent waterproof, anti-corrosion, moisture, electrical insulation properties
Suitable for thick film circuit system and printed circuit board coating ; LCM liquid crystal frame seal; other requirements of the application of good permeability;
Tack free time
Elongation at break
Tensile Strength Strength
(DC500V) Ω· cm
All of the above data were measured at 25 ° C, 55% RH for 7 days or after further test.
1, clean the surface: will be sticky or coated surface clean, clean with detergent to remove rust, dust and oil and so on.
2, sizing: the plastic mouth cut to the required size, into the glue gun. Squeeze the glue onto the cleaned surface to make the distribution evenly. When bonding, it will be fixed to the sticky surface can be fixed.
3, curing: the painted parts will be placed in the air, room temperature curing can be put into use after 24 hours.
4, Note: after opening a run out as much as possible, once, not use up again when used after edging out has formed part, continue to use, does not affect the normal use.
l the use of adhesive materials conventional metal, aluminum iron copper nickel tin;
l plastic category unless the polarity of the PE \ PP \ PTFE outside the ABS \
l PA \ PC \ PBT \ PET \ POM \ PPS \ PPO and other plastic materials;
l resin compatible, including acrylic, silicon, epoxy, polyimide resin, unsaturated polyester.
l rubber, including EPDM \ TPU \ PVC \ Si and other conventional rubber category
1, away from children.
2, recommended in a well-ventilated place to use.
3, if accidentally touched the skin, to be immediately washed with soap and water.
4, if accidentally stained eyes, should immediately rinse with water for a long time, while eyes wide open. If the stimulus is sustained, medical treatment is required.
USABLE LIFE AND STORAGE
l 30CC;310 ML;1L/plastic bottle
l Shelf life at 25℃: 12 months; if expired should be tested first.