Edge of the bending device power with mains voltage fluctuation about 50w (acrylic sheet thermal conductivity, high power make platesproduce blistering, excessive flue gas burn marks nigrescence)
Heating width 95mm, 2-4mm thick acrylic trim.
- 110V-120V / 220-240V
- Temperature adjustable
- Applicable materials: acrylic, PVC, plexiglass and various theromoplastic materials
- For 2mm thick acrylic, it needs 9-11 second
- EU/US plug (default for EU)
Note: It defaults for EU plug. If you need US plug, please leave a message when you place an order.
Product name:Acrylic heat Bending Machinery
packing size: 30*21*5CM
Type:120MM heating tube
Main uses: mainly used for all kinds of thermoplastic material bending angle and softening!
Applicable materials widely, such as acrylic, plexiglass plate, PVC materials and
various thermoplastic materials.
The same word strake and strake and strake on both sides of the iron on the edge of the heating, the two heating rods are respectively in the edge, such as edge folded inward, the inner heating rods attached to the ironing (heating rod at the bottom of the attached to the edge, the upper part of the left about 1.5mm), such as edge fold outward, the lateral heating rods attached to the edge ironing (heating rod at the bottom of the attached to the edge, the upper left about 1.5mm), bending operation, will always be on the side of the heating rod is attached to the edge, burn marks, the edge of the other side is smooth and straight mm thick edge of the heating time about 9-11 seconds, took off the iron, the edge fold to and literal stroke angle can be.