|Payment Terms:||L/C,D/A,D/P,T/T,Western Union,MoneyGram|
|Supply Ability:||1000 Box/Boxes per Day|
|Place of Origin:||Henan China|
|Product Name:||Generator charger 24V/12v|
|Power Consumption:||MAX. 3W|
SmartGen BAC06Awhich is designed for charging lead-acid starting battery according to its property. The charger is suitable for lead-acid battery float charge.the maximum charge current for 24V charger is 3A.
1) Designed in switching power structure, wide range of AC voltage input, small volume, light weight and high efficiency;
|Input Characteristi cs||Nominal AC Voltage||AC (95~280)V|
|Max. AC Voltage||AC (90~305)V|
|Max. Input Current||2A|
|Output Characteristi cs||Charging Current||4A~6A,(Error±2%)||2A~3A,(Error±2%)|
|Factory Charging Current||6A||3A|
|No-load Voltage||13.8V, (Error ±1%)||27.6V, (Error ±1%)|
|No-load power consumption||<3W|
|Insulation||Insulation Resistance||Between input and output, input and shell both are: DC500V 1min RL≥500MΩ I|
|Insulation Voltage||Between input and output, input and shell both are: AC1500V 50Hz 1min Leakage current: IL≤3.5mA.|
|Working Conditions||Working Temperature||(-30~+55)°C|
|Working Humidity||20%RH~93%RH (No condensation)|
According to charging property of the lead-acid battery, BAC06V battery charger uses 2-stage charging method and charge mode is "constant-current". When battery voltage is under the threshold, it is charging in constant-current mode; when the battery voltage is higher than the threshold,the charging
Output terminal of battery charger short circuit or battery reverse connection may blow the charger output fuse. In that case, after connecting AC power supply, charger green LED lights up but output terminal without voltage outputting, and then remove the output fuse tube to visually observe whether fuse is blown or not, if condition permit, multimeter can be used to measure the fuse status.
a) If output terminal 10A fuse is blown, users only need to change the same capacityfuse.
b) If output fuse isn’t blown or battery without outputting after changing the fuse, battery needs to depot repair.
c) Fuse burn emergency method: using conductive metal wire short connected burnt fuse, and then change the fuse later.
INTERNATIONAL AIR MAIL
Different amount of time will be required for different
|The ESD5500 series speed controller is an all-electronic device design, it uses fast and accurate response to instantaneous load changes to control the engine speed. This closed loop control, when connected to the electronic actuator and the speed sensor signal, uses an algorithm to stabilize the engine speed.|
|Working Voltage:||12/24V DC|
|Output Current Range:||0-5A|
|Operating Ambient Temperature Range:||-42°C - 85°C|
|Speed Trim Range:||± 200Hz|